If you have erased the bootloader or the config file you will have a dead router and need to recover using the JTAG method. Inside the unit you will find: a 14 pin JTAG connector (soldered on mine), 14 pin GPIO (unsoldered), 5 pin Serial (soldered), 10 pin serial (unsoldered), my flash chip was Samsung K8D3216UBC (It's next to the JTAG connector). wrt54g and check if your flash chip is listed. The serial cable will give you DMESG / debug information and is useful when trying to see why OpenWRT won't startĪnother thing to check before flashing or attempting to flash to openwrt is that your flash memory chip is supported by HairyDairyMaids debrick utility, otherwise you are stuck The JTAG will allow you to talk directly to the routers AR7 processor and restore the firmware. Before flashing please get a JTAG cable and (optionally) a Serial cable. If your router stops working use the recovery procedures outlined by D-Link first of all. I've got a D-Link DSL-502T AU, this is just a guide to de-bricking it and restoring the default DLink firmware, you should probably read this before you attempt to flash the router with Openwrt.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |